I put out a request for bids to several local house painters and quite a few seemed high. One was for over $6000 for painting the exterior of the house with putty fill as necessary, paint included. It was for him and one other guy to do the work. I said, "it's going to take you guys quite a while to get this job done" and he told me that no, they could do it in 2 days. I don't know about you but $1500 a day per painter seems more than just a bit high. I went with someone else and they had several people there for several days working like crazy and did a great job. There are too many scammers.
Most painters have no problem painting doors in place, but they recommend you lay the door on sawhorses and work horizontally. If you have a paneled door, start with the panels and work from the outside edges in toward the center. "Watch the corners — paint loves to puddle," warns Dixon. While the paint is still wet, lightly "tip off" the panel with an almost dry brush. (Tipping off is pulling the brush over the surface to level out the finish.) When painting the stiles (vertical) and rails (horizontal) just follow the grain of the wood. When the grain changes abruptly, for instance, where the rail meets the stile, don't stop your brush stroke — you'll only leave a lump of paint. Apply paint across the joint with a full stroke, and then tip off the overlapping section by pulling the brush in the direction of the grain. "Make sure the door is dry before painting the opposite side or rehanging it," says Maceyunas. 

Oh, where to begin? Let me start with 'watered down paint'. 25-50% before the material gets to the site? Impossible. You would basically be painting with water at that point. It would be less of a hassle, and cost, to simply use proper material. You would be forced to apply three coats instead of two, as the coverage would be horrible. Whatever cost you think might be saved in materials would be lost in labor.
To paint a large section without leaving lap marks, roll the nearly dry roller in different directions along the dry edge, feathering out the paint as you go. After completing the entire length of the wall or ceiling, move to the next section and paint over the feathered edges. For the second coat, apply the paint in the opposite direction. This crisscrossing paint application sharply reduces (if not eliminates) lap marks.
So sad that Angie's List requires the contractor be notified!! They have lost me as a client. If I'm dissatisfied and want to give an "F" rating (question/workers...I SHOULD NOT be intimidated into passing up an opportunity to explain my experience! There is NO WAY my contractor got an Aplus rating from over five hundred people....so someone was lying....yet I can't report that without the contractor knowing it? REALLY?
Second coats on similar colors are almost never recogicnized as being needed until the coat is applied and has dried. ONLY THEN WILL YOU SEE WHETHER IT NEEDS A SECOND COAT or not. Yes, painters can use a cheaper paint then what you paid for. That is solved by getting your own which, I would charge extra for because I will always have to go get more, or add second coat because home owner tried to skimp on paint, or they got the wrong color etc...
If you paint over dirty, oily surfaces, the paint will easily chip or peel off. So before painting, clean grimy areas with a deglosser or heavy-duty cleaner intended for prepaint cleaning. They work well to clean painted, varnished or enameled surfaces to improve the adhesion of the new paint. They’re ideal for cleaning greasy or oily areas like kitchen and bathroom walls and removing hand marks around light switches and doorknobs.
Picking exterior house paint colors is a lot different than picking a color for a shirt or a car.  It may help to drive around to observe colors that other homeowners have combined on homes that are of similar size and design as yours.  There are also online resources that provide homeowners with the ability to create virtual makeovers of their home by combining colors together through their software programs as well.
Lap marks are those ugly stripes caused by uneven layers of paint buildup. They occur when you roll over paint that’s already partly dry. (In warm, dry conditions, latex paint can begin to stiffen in less than a minute!) The key to avoiding lap marks  when doing DIY wall painting is to maintain a “wet edge,” so each stroke of your roller overlaps the previous stroke before the paint can begin to dry.
Enforcement of this Act by the Painter-Stainers Company was sought up until the early 19th century, with master painters gathering irregularly to decide the fees that a journeyman could charge, and also instigating an early version of a job centre in 1769, advertising in the London newspapers a "house of call" system to advertise for journeymen and also for journeymen to advertise for work. The guild's power in setting the fee a journeyman could charge was eventually overturned by law in 1827, and the period after this saw the guild's power diminish, along with that of the other guilds; the guilds were superseded by trade unions, with the Operative United Painters' Union forming sometime around 1831.[2]
Because of our wet/cold weather, another painter was booked out through August as of May 7th, 2016.  Anyone even thinking about a VA loan refi should get estimates for painting and pest inspections BEFORE starting on the loan paperwork, otherwise you will have difficulty getting painting and inspections done in a timely manner (and it is my understanding this is common with VA loans.)  
Attic Fan Installation Bathroom Fan Repair Ceiling Fan Installation Ceiling Fan Repair Electric Wall Heater Installation Electrical Panel Installation Electrical Panel Repair Electrical Panel Upgrade Electrical Wiring Installation Electrical Wiring Upgrade Exhaust Fan Installation Holiday Lighting Installation LED Interior Light Conversion Light Fixture Installation Light Fixture Repair Light Fixture Replacement Light Switch Installation Outlet Installation Outlet Repair Spa Wiring Installation
×