Being in the business for 25+ years I have had the privilege of working with thousands of clients. Although they all came from different circumstances and backgrounds they all had one common goal in mind. Every one of them wanted to be respected, receive top value for their money, and get the best possible paint job for their most prized possession, their house!
Disclaimer: NerdWallet strives to keep its information accurate and up to date. This information may be different than what you see when you visit a financial institution, service provider or specific product’s site. All financial products, shopping products and services are presented without warranty. When evaluating offers, please review the financial institution’s Terms and Conditions. Pre-qualified offers are not binding. If you find discrepancies with your credit score or information from your credit report, please contact TransUnion® directly.
Ideally, you want as much paint on the brush as you can control without making drips or blobs. To do this, Doherty dips his brush about 1 1/2 inches into the paint, then taps (not wipes) each side of the brush against the side of the can. Tapping knocks off the drips and forces the paint into the bristles. "The brush releases the paint just like a fountain pen," he says. Weeks agrees, saying, "Just be sure to keep your brush moving, or it'll start to drip." For more delicate work, such as when you're painting trim or window sash, you'll want less paint on the brush. Doherty again dips and taps his brush, but this time he also scrapes the sides against his can. "The outside bristles are drier and easier to manage," he says, "but there's still plenty of paint on the brush."
To maintain a wet edge, start near a corner and run the roller up and down the full height of the wall, moving over slightly with each stroke. Move backward where necessary to even out thick spots or runs. Don’t let the roller become nearly dry; reload it often so that it’s always at least half loaded. Keep the open side of the roller frame facing the area that’s already painted. That puts less pressure on the open side of the roller, so you’re less likely to leave paint ridges when doing DIY wall painting.
PSA: Color psychology is a thing. The right soothing hue can work wonders for your mind and soul. You might think that only works for pale blues, but the contrast of a light and dark color — or, in this case, off-white walls with chocolate brown and deep blue accents — has a powerful effect. "The darker color grounds the room, and then the lighter runs right up to the ceiling and makes it feel higher. It creates this serene atmosphere," designer Laura Bohn told us.
The pros were split on this tip. "Masking tape is problematic," says Mark Dixon, a painter in Missoula, Montana, and author of "House Painting Inside and Out" (Taunton Press, 1997). "Paint can bleed behind the tape, or remove the paint it's stuck to." Another problem is bridging. "Latex paints form a skin," says Dixon. "Removing painted tape can tear the skin, resulting in a ragged rather than a sharp line." Lastly, taping takes time. "Learning how to cut in with a brush takes practice, but if you can do it, you'll leave most tapers in the dust," Dixon says. (Cutting in is painting just the surface you want, not the surface adjacent to it — for example, where a wall meets the ceiling.) On the other hand, "If you can't cut in, you can't beat tape," says Span. The pros we spoke with all recommend painter's (blue) tape because it's easier to remove than masking tape. To prevent bleeding, Span uses a putty knife to bed the tape. After letting the paint dry, he scores the edge of the tape line with a utility knife to avoid tearing the paint.
When the primer is dry, caulk all small joints (less than ¼-inch-wide) in the siding and trim. Most pros use siliconized acrylics—paint won't stick to straight silicones—but Guertin and O'Neil like the new, more expensive urethane acrylics for their greater flexibility and longevity. O'Neil stresses that it's shortsighted to skimp on caulk. "If the joint fails, you're back to square one." Guertin uses the lifetime rating as his quality guide. "I don't expect 35-year caulk will last 35 years, but it should last longer than a 15-year caulk."
When painting the trim, you don’t have to be neat. Just concentrate on getting a smooth finish on the wood. Don’t worry if the trim paint gets onto the walls. You’ll cover it later when painting the walls. Once the trim is completely painted and dry (at least 24 hours), tape it off (using an “easy release” painter’s tape), then paint the ceiling, then the walls.
Attic Fan Installation Bathroom Fan Repair Ceiling Fan Installation Ceiling Fan Repair Electric Wall Heater Installation Electrical Panel Installation Electrical Panel Repair Electrical Panel Upgrade Electrical Wiring Installation Electrical Wiring Upgrade Exhaust Fan Installation Holiday Lighting Installation LED Interior Light Conversion Light Fixture Installation Light Fixture Repair Light Fixture Replacement Light Switch Installation Outlet Installation Outlet Repair Spa Wiring Installation
The BBB isn't a painter-specific group but rather an organization that is dedicated to ensuring that consumers can access information about anyone they do business with. The BBB also rates companies based on a Standards of Trust scale, which goes from A+ to F. A company doesn't have to be a member to get a grade, and it's a good idea to check to see how your contractor is scored as well as its membership status.
The paint on your home or business can be one of the most influential factors when it comes to the overall look and feel of your property. Unfortunately, time and weather can begin to dull your exterior and interior paint. At Texas Professional Painting, we combat the wear and tear process by providing you with a fresh coat of beautiful every time! We have been the professional painters San Antonio prefers for over five years!
The only time it's acceptable to mix water in the paint is when you're using a deep or ultra deep base paint to reduce its stickiness, which is rare with new paint technology. Dark primary colors are composed almost entirely of tint that makes it very hard to work with without adding water. (You never use a sprayer and need to thin paint.?) If i was still in the industry I'd take the time to make a better article than this. Take this for a grain of slat. Use a reputable painter or someone you know you can trust or has been referred to you by someone you trust. I wouldn't hire anyone I had to watch like a hawk to make sure they're not screwing me.