Homeowners with wood siding have the option of staining or painting siding that has been worn down by the elements -- especially if they need to increase its defenses against the sun or extreme humidity. Holes, missing pieces or other problems will increase the overall cost of the painting project. You can expect to pay between $700 (~250 sq. ft.) and $2,000 (~1,000 sq. ft.) to paint wood siding, but this project will also help to protect the home's exterior from more extensive repairs down the road.
Painters will need several supplies for your home exterior project in addition to paint. Consider personally providing any materials that can be obtained without a license to reduce project costs. Painting supplies are also handy to have around for maintenance and touch-up jobs after the job is complete. The cost to invest in painting supplies will probably run you no more than $200 to $300, unless you buy really high-quality products from specialized paint shops. Consider purchasing the following:
A number of factors help determine when you should paint your home’s exterior. These include your local climate and weather conditions, the age of your home, and the type of siding used. A high-quality finish in ideal conditions could last 10 years. But if your home takes a beating from the elements, you may need to repaint as often as every three years. Most homes can be on a 5-8 year interval. If you’re not sure if your house is due for a refresher, watch out for signs of deteriorating paint, such as fading and chipping.
When coverage is difficult to estimate, add more rather than less when doing DIY wall painting. You can always pour the leftover back into cans. For large jobs, use the bucket and a roller screen rather than a roller tray. It’s much faster to load your roller with the screen than to use a roller pan. Simply dunk the roller into the paint bucket, then roll it along the screen until it stops dripping.
Third: The contractor buys the materials. We get them at a better rate and customers really don't know what they are getting into by being a material racer. Once again, I'm not referring to the guys that paint a bedroom or 2 a week. Tell the homeowner to go grab 50 gallons of paint, $300.00 worth of sundries and related job cost items and I'd be interested to see how it works for them....IT WILL NOT. And if were talking about people getting taken advantage of here, the paint suppliers with no relationship to a homeowner will 100% GOUGE the customer and completely take advantage of them with pricing. Contractors will pay nearly half the price and will still save the customers money marking up paint 10-15%.
Using the right software makes your job much easier and helps you get the best possible results. You can easily find the right paint combinations to please your client and quickly order the paint from a nearby store. A good field service management application, such as mHelpDesk, allows all departments of your business to smoothly coordinate their efforts, eliminating wasted time and producing happy customers.
For most people, their home is their most valuable asset and that’s why it needs to be painted exclusively by professionals. Think about it; you wouldn’t paint your car, so why would you consider painting your home? Rather than putting your most valuable asset at risk, not to mention your own safety and well-being, trust the Fort Worth painters of Southern Painting to get the job done quickly, safely, efficiently and properly.
My wife and I just painted the interior of our house with about 6-8 gallons, of $30+ per gallon (meaning the good stuff, non-diluted) with absolutely fantastic results. However we just paid an average of $5 per gallon. Reason...all big box stores have paint, set aside, that has been mixed but not picked up by the customer. They need to sell it quick and if you're not in a hurry (you know well in advance that a room or two need painting and it's not like the roof leaking and needs an immediate fix) you can go to each store when you need other supplies or food, like Walmart (when convenient, driving 20 miles to each is not worth it) and over the course of a month or two, pick out some very nice colors of quality paint. We found perfect colors...not saying they were our first choice but when we opened the can, very nice and some even better than our original picks. Cost to paint the entire house was about $100, with all materials included, period. We had it on the market for a few months to sell, didn't sell, painted the rooms, got 2 offers the day after we finished, took the best one and never looked back.
Lap marks are those ugly stripes caused by uneven layers of paint buildup. They occur when you roll over paint that’s already partly dry. (In warm, dry conditions, latex paint can begin to stiffen in less than a minute!) The key to avoiding lap marks when doing DIY wall painting is to maintain a “wet edge,” so each stroke of your roller overlaps the previous stroke before the paint can begin to dry.
Thorough preparation is essential to ensure a good finish. Contractors might have to fill cracks or holes and remove old paint if it is badly worn, peeling or flaking. They remove all paint and apply a suitable primer to the bare surface. If the existing paint is in reasonable condition, they clean it and rub it with abrasive material to provide a key for the new paint. On new surfaces, such as bare wood or fresh plaster, they apply a suitable seal, followed by a primer coat.
Unless you like textured walls, don't paint over dust. Wash the walls with trisodium phosphate (TSP) or a mild cleaner, like Jasco's TSP No-Rinse Substitute. For smoke-stained walls, Toto uses a 50/50 solution of bleach and water. To clean a wall, use two buckets. Load up your rag or sponge from your cleaning-solution bucket, and scrub. Before redipping, rinse the sponge in a second bucket filled with clean water.
When painting the trim, you don’t have to be neat. Just concentrate on getting a smooth finish on the wood. Don’t worry if the trim paint gets onto the walls. You’ll cover it later when painting the walls. Once the trim is completely painted and dry (at least 24 hours), tape it off (using an “easy release” painter’s tape), then paint the ceiling, then the walls.
You are right on with this - why do people leave switch plates on when it's just so easy to take them off? Another thing that happened to us - we had the popcorn ceiling taken off and the ceiling painted white. When the job was done and I later went to change out all the fixtures/fans, they had left every fixture in place, so there was a large patch of popcorn and unpainted ceiling left behind - it just didn't dawn on me to specify that they take those down before scraping and painting. It was kind of a mess.
Sanding not only feathers out chipped paint but also provides "tooth" for the next coat of paint. For glossy trim, use a sanding sponge rather than sandpaper. Sponges mold to the shape of the trim and last longer than paper. When applying latex over alkyd paint or when he is not sure of the original finish, Brian Doherty, a painter in Richmond, Virginia, follows the hand-sanding with liquid sandpaper to make sure the surface is completely deglossed to prevent incompatibility problems. "I've seen homes where latex was used on oil-painted trim, and the paint started to peel in less than a year," says Doherty.
When selecting a color scheme for the home’s exterior homeowners can choose color options that will correct flaws that they may feel exist with their home and property. Some examples include utilizing two shades of a single color to make a home appear appropriately sized when the home may be too large or too tall. To accomplish this effect individuals will want to place the darker tone on the upper level of the home’s exterior. Smaller windows can appear more proportionately sized by trimming them in a lighter tone of paint. Darker colors make a space or feature appear smaller. The same effect can be obtained for homes positioned further away from a curb. By using lighter tones the home will not feel camouflaged.
The question, “how is your warranty program funded?” will probably get you some puzzled responses. The fact is, most contractors have never even considered how to pay the expenses associated with warranty callbacks, and some contractors just seem to vanish when they get a warranty call. A professional contractor will be preparing for callbacks (they will happen, even to the best contractors) by including a line item in their budget for warranty work. Ask the question and see what kind of response you get. Sometimes, how the question is answered is more important than the answer itself!
I'm an architect and my firm routinely specifies interior finishes for projects so I thought I'd contribute a professional's perspective on the issue of how many coats of paint are deemed "acceptable". The fact of the matter is the average consumer usually isn't a paint expert and can't be expected to know about all the factors that impact coverage. That knowledge is considered "means and methods" and in a court of law, the responsibility lies with the painter or general contractor, not the consumer. What the consumer should be concerned about is the final result-does it look good and is it what you expected? The simplest way to communicate this to your painter is to stipule in your written agreement that the number of coats will be "as required to cover". That way all the guess work about what kind of primer, how many coats, how color affects the scope of work, etc., is removed from the consumer's responsibility and resides where it belongs-with the professional. In the contract that's why retention is always a good idea-typically 10% is withheld from payment until the job is completed to the satisfaction of the customer. Of course in return you as the customer have to be reasonable about what constitutes a completed job. Just my $.02.