As you walk through your lighted rooms (preferably day light) see if the new coat has light spots showing the precious paint. This is call "bleeding through". This means that there's only one coat of paint or the paint was diluted or the trasition of colors were from light to dark (or the other way around) and primer was not use or the painter is inexperienced.
The best time of the year to paint your home is typically in late spring and early summer when it’s warm outside and moisture is low. This can change based on your geographic location. For example, fall can be a good time to paint in California when the difference between high and low temperatures is low. Your painter will select the optimal time to start your exterior painting project.
After any areas repaired in the previous step are primed, we apply premium quality paints for a uniform finish. There are multiple finish options, including flat, matte, eggshell, satin, semi-gloss, and high-gloss, and we will have gone over the benefits of each with you beforehand so you can make an informed decision. The time will vary depending on the size of the job, but we will always ensure to work as quickly and efficiently as possible.

"We used Next Door Painting for the exterior and one room on the interior of our house. Scott Finkelstein and his crew did an excellent job. They were reasonably priced, very professional, helpful with ideas and accommodating to our wishes and needs. I was contacted within an hour after my Thumbtack request, made an appointment for an estimate and was impressed with the knowledge and quality of the presentation. I definitely recommend them for the job and will use them again. Christy Todd Flower Mound, TX"


Sanding not only feathers out chipped paint but also provides "tooth" for the next coat of paint. For glossy trim, use a sanding sponge rather than sandpaper. Sponges mold to the shape of the trim and last longer than paper. When applying latex over alkyd paint or when he is not sure of the original finish, Brian Doherty, a painter in Richmond, Virginia, follows the hand-sanding with liquid sandpaper to make sure the surface is completely deglossed to prevent incompatibility problems. "I've seen homes where latex was used on oil-painted trim, and the paint started to peel in less than a year," says Doherty.
I am a painting contractor and have been since 2001. Make sure the estimate provides in writing: What is EXCLUDED as well as INCLUDED. It should state the manufacturer and type of paint going to be used. Estimate says ALL LABOR AND MATERIALS. My estimates to my customers say "guaranteed coverage" eliminates the conversations of 1 coat vs 2 coat. I have my customers submit colors 5 days prior to start date. Customers need to inform me if they are going to use pure white, dark reds, oranges, and bright yellows they need to inform me in that 5 day window, so I can adjust my pricing for 3 coats. Although this more uncommon now than years past because a lot of paint manufacturers have primer with paint products. Let the contractor know if your doing accent walls. This takes longer to cut in straight lines and it requires the contractor to purchase more paint. If you add anything on the scope of work have the painter write out the description and cost prior to them doing the work. Have the estimate say how many days it will take to perform the work. Ask how many workers will be doing the job. Make sure to enforce that number of workers their everyday until the job is complete. Do not give final payment until you do a final walk through. Walk the job when its almost complete and point out areas that you want fixed prior to the contractors final walk through. Its best to do while the workers are still in that particular area as they will have tarps down and areas covered and it will be easier for them to take care of. Purchase a roll of blue tape and stick it to areas that you want fixed. This is called a punch list.
Ideally, you want a variety of older and newer projects, and you especially want to check on a very recent project, such as something completed last month. When you do get the references list, don’t take the information for granted. Take a few minutes to check these references. Ask these homeowners about the experience while services were provided and also how well the job has held up over time.
When you’re ready to tackle your next paint project, we offer an amazing choice of colors from top paint brands, at the best price, and expert know-how to help you do the job right. Whether you’re making a colorful update to the interior or exterior of your home or working on a unique DIY project, you can really pour on the creativity with our unmatched selection of paints and exterior stains, craft supplies like chalkboard paint, stencils, glitter, or even glow in the dark spray paint. You should also check out our paint project and buying guides as well as The Home Depot Blog for current paint trends, popular color palettes and paint craft ideas. For all your painting needs, small and large, we’ve got you covered at The Home Depot.
The quickest way to up the curb appeal of your home? A fresh coat of stain or paint. At Five Star Painting, we specialize in exterior home services that make an impact. Contacting one of our local residential painting experts means there will be no hassle and no mess for you and your family. Our teams come highly recommended and can help with everything from pressure washing to paint selection.
The cost to paint metal siding -- most commonly aluminum and galvanized steel -- will depend on a variety of factors. In some instances, a simple cleaning will suffice to prepare metal siding for painting. In worst cases, painting professionals will need to repair metal that is rusted, damaged or missing pieces due to climate conditions. In the case of severe damage, a professional will have to remove the old finish and paint to get to the original layer, which will add on to the final price. When you add the actual painting of the metal siding, you might be looking at a final bill between $400 (~250 sq. ft.) and $1,500 (~1,000 sq. ft.).

"Modern paints dry too quickly, and are difficult to brush out," says Dixon, who uses paint additives, such as Floetrol for latex paints and Penetrol for alkyds. "Adding a few ounces per gallon slows drying time and makes the paint more workable," he says. Another problem is bridging. "Latex paints form a skin," says Dixon. "Removing painted tape can tear the skin, resulting in a ragged rather than a sharp line." Lastly, taping takes time. "Learning how to cut in with a brush takes practice, but if you can do it, you'll leave most tapers in the dust," Dixon says. (Cutting in is painting just the surface you want, not the surface adjacent to it — for example, where a wall meets the ceiling.) Although there are mildewcide additives, our pros prefer using bathroom and kitchen paints that have built-in mildew fighters. "These paints will prevent mildew from forming, but they won't kill mildew that's already there," Dixon points out. Because leftover mold spores can live beneath the paint and eventually work their way through to the surface, you should also prep bath and kitchen surfaces. First, wash down the walls with a bleach solution (3/4 cup of bleach per gallon of water) then seal with a stain-blocking primer, such as Zinsser's Bulls Eye 1-2-3 or Kilz's Total One.
Remember: You want to get the highest quality paint your budget will allow to ensure its lasting beauty. You'll also need painting supplies like primer, brushes, rollers and painter's tape. A professional will have these items on-hand. According to statistics, paint and other supplies account for about 15 percent of a professional painter's total cost; labor will factor into 85 percent of their charges.

to be the devils advocate i have been a building contractor 20 of the last 30 yrs. i do know that if you go to a higher sheen of paint and or darker colors then any imperfections in the walls will show up much more dramatically…therefore the painter or a good drywall finisher is needed to prepare the walls extensively. this could cause more expenses…for it takes a lot of time to prep walls (smooth walls..not textured walls) and this cost has to be absorbed.
I would never suggest that one of my clients buy their own paint because A . They will pay an average of $20 to $30 more per gallon which could add up to $1,000 or more to a full repaint B. most times I'm in the paint store homeowners are kind of pushed to the foreground as they handle all the contractors in the store and C. Paint is heavy, takes up a lot of room needs to be left in it clean dry area and I hate to put a client to work when they are trying to hire me to do their job.
Good contracts include descriptions of prep work and repairs; paint specs by brand name, type, color and product number; the number of coats; and a full description of the work, including frequently omitted items such as cabinet interiors and shutters. Minimize delays by specifying that, weather permitting, work will be continuous. Get a payment schedule that minimizes the down payment — the more payment you can withhold until the end, the more leverage you'll have to get the job done well and per your specifications. Insist that contractors provide proof that they carry both general liability and workers' compensation coverage.
On its last day, I was listening to see how they would handle it. They brought in personalities who were friends of the station for interviews, played some popular pieces, and were set to sign off at the appointed and anointed 10 p.m. They put on a recording of Beethoven’s 9th, which for many people still holds its place as the finest piece of Western music ever composed. But what would they say afterwards? I waited to hear, and they said the classiest thing they could: nothing.
The BBB isn't a painter-specific group but rather an organization that is dedicated to ensuring that consumers can access information about anyone they do business with. The BBB also rates companies based on a Standards of Trust scale, which goes from A+ to F. A company doesn't have to be a member to get a grade, and it's a good idea to check to see how your contractor is scored as well as its membership status.
A qualified exterior house painter can walk you through the process of getting your house ready for a new coat of paint, from scraping and sanding to patching and priming. A pro can also recommend the best exterior paint for the job, whether your siding is wood, fiber cement, stucco, vinyl, or even metal. When it comes to getting the work done, your painter will arrive with all the tools and equipment needed to get the job done quickly, correctly and safely.
Here is where this affects you as a consumer. You select a painter with a contract that says 2 coats, $500 down. You give the company the deposit and pick your colors a couple of days before the project starts. The painter goes to the store with your colors and figures out they are deep base. He (or she) not only needs to charge you more for the paint, but he also needs to charge you for a dark gray primer coat. Ninety nine percent of the time that primer coat is going to be really, really expensive since you already gave a deposit.
Our team of industrial, commercial & residential paint contractors have many years of experience working on projects of all sizes. All projects are managed and staffed by in-house professional employees from start to finish. With our attention to detail and commitment to excellent customer service, you can be assured that your project will be successfully completed on time and within your budget.
we only use the best interior paint which goes further as far as pricing a repaint we charge 2.00 a square foot floor space for walls ceilings and trim .on new construction using the best paint 3.90 per foot floor space that is with 3 coats on all surfaces but as being a professional for 45 years i recommend use a professional so that your paint will last longer and you wont have to pay to have it done more often i do free consulting in these areas i am more than happy to assist you with your projects 864-506-6666 just always remember good paint last longer and use a washable paint your home is your most valueable investment take care of it
Your home is your most important asset and maintaining it is vital in upholding and increasing its value. As a full-service painting company, Home Works Painting will provide you with a superior professional painting experience. Our services include interior/exterior painting, drywall repair/installation, wood replacement, pressure washing, and color consulting. We stand behind our work by offering a six year warranty.

"Modern paints dry too quickly, and are difficult to brush out," says Dixon, who uses paint additives, such as Floetrol for latex paints and Penetrol for alkyds. "Adding a few ounces per gallon slows drying time and makes the paint more workable," he says. Another problem is bridging. "Latex paints form a skin," says Dixon. "Removing painted tape can tear the skin, resulting in a ragged rather than a sharp line." Lastly, taping takes time. "Learning how to cut in with a brush takes practice, but if you can do it, you'll leave most tapers in the dust," Dixon says. (Cutting in is painting just the surface you want, not the surface adjacent to it — for example, where a wall meets the ceiling.) Although there are mildewcide additives, our pros prefer using bathroom and kitchen paints that have built-in mildew fighters. "These paints will prevent mildew from forming, but they won't kill mildew that's already there," Dixon points out. Because leftover mold spores can live beneath the paint and eventually work their way through to the surface, you should also prep bath and kitchen surfaces. First, wash down the walls with a bleach solution (3/4 cup of bleach per gallon of water) then seal with a stain-blocking primer, such as Zinsser's Bulls Eye 1-2-3 or Kilz's Total One.

Primers aren't just diluted paint. They're formulated to establish a solid, even base, seal stains and ensure that the topcoats of paint go on smoothly and bond securely to the surface. "Most homeowners use latex primers, but the pros stick to alcohol and alkyd primers because they'll cover almost anything," says John Weeks, of John the Painter in Mobile, Alabama. Primer can affect the appearance of the topcoat. "It's okay to spot-prime the ceilings but not the walls, because primed spots will show," adds Span. persuasiondesign.info
×