I did go with the highest bidder and it did not matter. They did a shoddy job and threatened to take me to court when I pointed out mistakes that they made based on their work standards stated on the quote. I have not paid them yet, just filed a complaint with the BBB. No money down asked, no contract signed. The boss stated I have to high of expectations just because I live in a 121 year old house!
House Painter Company
Unfortunately, there are plenty of cases where a painter has stolen items from a home or caused damage to the house or injury to the homeowner. Subcontractors may not be as skilled as employees, and the contractor you're hiring may not have much experience working with them, making them more of a risk. Additionally, ask if the painters are employees or subcontractors, and what the screening or hiring process is like.
To paint a large section without leaving lap marks, roll the nearly dry roller in different directions along the dry edge, feathering out the paint as you go. After completing the entire length of the wall or ceiling, move to the next section and paint over the feathered edges. For the second coat, apply the paint in the opposite direction. This crisscrossing paint application sharply reduces (if not eliminates) lap marks.
There are permanent features of the home that have their own colors which cannot be changed when painting the exterior of the home but can have a dramatic satisfaction level that is experienced when the painting is completed. Roofing shingles, paving blocks, concrete surfaces, stones and other such features are prime examples of the colors that should be considered when selecting your exterior color scheme for the home. Homeowners can work off of these colors to make a home that looks uniform and luxurious when the exterior painting is complete.
Repaint — exteriors especially — before visible signs of wear appear, Bancroft says. Don’t wait until you see peeling or flaking paint. “If I have to spend 40 hours preparing the surface before we can paint, that time is going to result in a lot of extra costs. But if I can spend 10 hours preparing the surfaces to be painted, you’re going to save money,” Freeman says.
The best time of the year to paint your home is typically in late spring and early summer when it’s warm outside and moisture is low. This can change based on your geographic location. For example, fall can be a good time to paint in California when the difference between high and low temperatures is low. Your painter will select the optimal time to start your exterior painting project.
Thanks, all, for your time & efforts adding to the article & comments, especially Dave urging requesting both General Liability AND Worker Compensation insurance certificates to protect from real & fraudulent liability--from my experience especially in California, where insurance fraud is a popular income thief, even causing car collisions to collect.
we only use the best interior paint which goes further as far as pricing a repaint we charge 2.00 a square foot floor space for walls ceilings and trim .on new construction using the best paint 3.90 per foot floor space that is with 3 coats on all surfaces but as being a professional for 45 years i recommend use a professional so that your paint will last longer and you wont have to pay to have it done more often i do free consulting in these areas i am more than happy to assist you with your projects 864-506-6666 just always remember good paint last longer and use a washable paint your home is your most valueable investment take care of it
I put out a request for bids to several local house painters and quite a few seemed high. One was for over $6000 for painting the exterior of the house with putty fill as necessary, paint included. It was for him and one other guy to do the work. I said, "it's going to take you guys quite a while to get this job done" and he told me that no, they could do it in 2 days. I don't know about you but $1500 a day per painter seems more than just a bit high. I went with someone else and they had several people there for several days working like crazy and did a great job. There are too many scammers.
The last big decision is how to apply the paint. Most pros use paint sprayers because they're fast, but in inexperienced hands a high-powered sprayer can leave drips, thin coats, and a mist that may land on many things other than your siding. If you do hire a painter who uses a sprayer, make sure he is meticulous about removing, covering, or masking off everything in the area that might get hit with overspray: gutters, roofs, windows, shrubbery, walkways, cars—you name it.
Hmmm...Intro to E12...looks suspiciously like a freehand angled cut on that contractor saw... Yes, the riving knife might save you from a dangerous kickback...but still a very bad idea.. Why not a 'safety segment' explaining kickback and why you should not do this (styrofoam demo, back side of the blade teeth rising up grabbing the foam and throwing it back at you...)
To get basic measurements, measure the length and width of each wall you want to paint in inches. Multiply the length and height together, and divide by 144. This will give you the square footage for each wall. A gallon of paint typically covers around 400 square feet. In some cases, you may need a primer 2 first, then a single coat of paint, meaning that you may need one gallon of primer and one gallon of paint to cover 400 square feet. However, if the wall requires multiple coats, this will increase the total amount of square footage required, and therefore the amount of paint.
Some proposals simply say to paint the walls and ceiling and never specify the number of coats to be applied. If the colors are similar enough, it's possible to get away with one coat of paint and not discount your pricing. No matter how hard you try, tiny, pin-sized air holes will pop exposing the original walls. This may not bother you if you can't notice it, but principally speaking you should have paid your painter less for the work.
Even an old lamp with a bare bulb held close to a wall will make minor cracks, bumps or nail pops jump out. Carmen Toto, owner of C. Toto & Sons in Madison, New Jersey, uses painter's putty or a lightweight spackle for minor cracks and dents; he uses plaster of Paris for dents deeper than 1/8 inch. Instead of the standard tape-and-spackle method for bridging over recurring stress cracks, Maceyunas uses a rubberized spray-on primer called Good-Bye Crack. Damaged wood requires a slightly different approach. "Don't use spackle on wood," says Toto, "because it just won't stick." For damaged trim, he uses painter's putty or a two-part wood filler, such as Minwax's High Performance Filler. Smooth any repairs, bumps, and nibs with a drywall pole sander. For smoother walls and better adhesion, some of our pros sand all previously painted walls regardless of the shape they're in.
I am in northern Nevada and you have not yet gotten sufficient responses to provide a painting cost chart showing the averages. I do have a quote from an outside (Not Homeadvisor referral) painter who is local for $2,750 for soffits, patio cover and posts, Garage facia (redwood clapboard above (~300 ? Sq. Ft.) on a 2046 Sq. Ft. home where the walls are 9 ft tall and it is fully stuccoed with plastic stucco surfaces, so not being painted.
O'Neil patches shallow holes and divots with Ready Patch because it dries fast, sands smooth, and stays flexible. Deep cracks and rotten spots are best repaired with two-step epoxies, such as those made by Advanced Repair Technology. (For a step-by-step instructions, see Repairing Rot with Epoxy.) The days of using polyester auto-body fillers on wood are over. "They cure too hard," says Portland, Oregon–based painting contractor Kathleen George. "They look good at first, but then they peel away."
Thorough preparation is essential to ensure a good finish. Contractors might have to fill cracks or holes and remove old paint if it is badly worn, peeling or flaking. They remove all paint and apply a suitable primer to the bare surface. If the existing paint is in reasonable condition, they clean it and rub it with abrasive material to provide a key for the new paint. On new surfaces, such as bare wood or fresh plaster, they apply a suitable seal, followed by a primer coat.
I turn away any job when the client refuses to pay anything up front. It sends a red flag. I also charge a scheduling fee which is non-refundable. I get 33 percent when I show up and begin work. Another percentage halfway through, and the balance upon completion after client is satisfied. There needs to be skin in the game for both parties as a measure of good faith. If you are dealing with a reputable company (did your due diligence, right?) why wouldn't you want to pay something as work progresses? We do this not only because we love to paint but we require cash flow to stay in business. There is not always 'money in the bank' as you suggest. It's tough these days. The suggestion buy 'Kim' 'Never pay a contractor a deposit' is nonsensical.
To win work, contractors generally have to bid against other suppliers. To make an accurate bid, they estimate the time and materials required to complete the job. They measure the area to be painted and discuss the type of finish the customer requires. They assess the quality of the surfaces to work out how much remedial work they must carry out before painting. They might have to remove old paint or wall coverings, or repair cracks and other damage. They also calculate the cost of any essential equipment, such as scaffolding for exterior walls.