A painter's rod, or pole, can help you paint ceilings more quickly — no climbing up and down ladders required. And there's no need to stand directly underneath the area you are painting, so you won't catch every wayward splatter. A pole is also great for walls and floors. The pros were split over whether the 4- or 8-foot pole is best for everyday use, but they all agreed that a telescoping rod is the best bet.
To paint a large section without leaving lap marks, roll the nearly dry roller in different directions along the dry edge, feathering out the paint as you go. After completing the entire length of the wall or ceiling, move to the next section and paint over the feathered edges. For the second coat, apply the paint in the opposite direction. This crisscrossing paint application sharply reduces (if not eliminates) lap marks.
The PPG logo is a registered trademark and Colorful Communities and We protect and beautify the world are trademarks of PPG Industries Ohio, Inc. © 2019 PPG Industries, Inc. All Rights Reserved. | Legal Notices & Privacy Policies | CA Transparency in Supply Chain Disclosure | Global Code of Ethics | TISC for PPG Architectural Coatings UK Limited | TISC for PPG Industries (UK) Limited | PPG Industries UK Ltd 2017 Gender Pay Gap Report
I've seen this article sent out 4 times now. It's out dated in terms of today's "Scams." Paint stores haven't charged more money for deeper paint colors in over 15 years. Also Water downed paint? Seriously? That would never happen in the real world. And Wall repair? what painter would ever not assume wall repair as included? This article is a waste of time and should be taken down or edited to reflect actual scams of todays times.
Painting the exterior of your home is an essential maintenance task that can be challenging, time-consuming and extremely messy. The fastest and safest way to get the job done right is to hire a professional exterior painting contractor. A pro will have the right tools, equipment, and experience for the job, will be able to recommend the most effective paints for your particular project, and can handle the necessary prep work to ensure a lasting finish. They will also select the best time to paint your home to keep the project within your timeline and budget.
My painter franchisee, who I got from Angie's List, must have found some shmucks on the corner to paint my house. I specifically said I wanted stain. First my house was painted the wrong color, Then it was painted with LATEX paint- not stain. Estimates to 'undo' the damage is around $10,000 and its not a guarantee that it will work. The work is at best amateurish. Many underpainted or not painted spots, drips, etc. They did the entire outside (scraping?, priming? caulking?, painting), cleaned up and left within the time I left for work and came home. There were thee of them (my neighbor told me) This was two years ago and I am still upset. Can't be fixed.
The article and comments were great information to have before deciding how to go about getting a painting job done. I think the important point is that there are several key choices (who to do the work; color, sheen, quality, of paint; how many coats; amount of prep/repairs to be done and by whom, how long the job will take, provisions for changes, how detailed the contract needs to be; advanced deposit/progress payments/final payment; final inspection, etc.) that need to be made and it requires advanced research and planning in order to become well enough informed to make the right choices. Then it requires spending sufficient time to check materials and inspect the quality of the work while it is on-going, raher than waiting to do it all at the end. President Reagan's philosophy of "Trust, but verify." applies.
To maintain a wet edge, start near a corner and run the roller up and down the full height of the wall, moving over slightly with each stroke. Move backward where necessary to even out thick spots or runs. Don’t let the roller become nearly dry; reload it often so that it’s always at least half loaded. Keep the open side of the roller frame facing the area that’s already painted. That puts less pressure on the open side of the roller, so you’re less likely to leave paint ridges when doing DIY wall painting.
As you walk through your lighted rooms (preferably day light) see if the new coat has light spots showing the precious paint. This is call "bleeding through". This means that there's only one coat of paint or the paint was diluted or the trasition of colors were from light to dark (or the other way around) and primer was not use or the painter is inexperienced. 

Small random-orbit or pad sanders make this job go faster. (Wallis first covers these boundaries with Synkoloid patching compound so no edge is visible after sanding.) As shown, you want to make sure that there is a feathered, smooth transition from exposed wood to old paint. For areas that might get close scrutiny, you can follow up with a 100- or 120-grit rubdown to erase any scratches.

I am in northern Nevada and you have not yet gotten sufficient responses to provide a painting cost chart showing the averages.  I do have a quote from an outside (Not Homeadvisor referral) painter who is local for $2,750 for soffits, patio cover and posts, Garage facia (redwood clapboard above (~300 ? Sq. Ft.) on a 2046 Sq. Ft. home where the walls are 9 ft tall and it is fully stuccoed with plastic stucco surfaces, so not being painted.  

Painting Company

×