The materials of the home’s facade should be considered before painting your home. When painting flat surfaces like siding or wood, you can opt for standard outdoor paint. When painting a textured surface like stucco or brick, “elastomeric” paint is a much better choice. This type of paint can stretch more than normal paint, which allows it to bridge over small gaps and crevices, painting smoothly over texture.
If you have ornamental or colorful trees, shrubbery or floral selections around your home you should figure their colors into the color scheme selection that is made.  These landscaping attributes will have an effect on how appealing the property is as a whole throughout the year.  Homes that have a great deal of trees can make the property darker and cast shadows onto the home.  Individuals will want to avoid darker colors for these situations.

When hiring a contractor it is always best to hire one who is personally referred to you by someone you trust. Hiring through ads or phone book is hit and miss. Check with your local paints stores, they know the good guys from the bottom feeders. Go to the stores that sell the high quality paints like Benjamin Moore(nonpareil), Pittsburg, Sherwin Williams or Glidden. Don't go the the big box stores for referrals, the people there don't know squat!


To get basic measurements, measure the length and width of each wall you want to paint in inches. Multiply the length and height together, and divide by 144. This will give you the square footage for each wall. A gallon of paint typically covers around 400 square feet. In some cases, you may need a primer 2 first, then a single coat of paint, meaning that you may need one gallon of primer and one gallon of paint to cover 400 square feet. However, if the wall requires multiple coats, this will increase the total amount of square footage required, and therefore the amount of paint.
Another factor to consider is the height and features of your home. An example would be a house completely trimmed in Cement Fiber, which does chalk if you do not purchase the correct paint and apply enough of it. Some houses in Coastal Areas are already on 15+ft Stilts (off ground) and then another 20ft high at times. This requires rental equipment and careful cost estimation based on the difficulty of the overall project, The best advice that I can give is to get several estimates in your area and make a decision a couple of weeks afterwards. You will "weed out" per se the individuals that do not have the patience to finish a project that was started-as well as those who haggle you for payment (sometimes daily) before project is completed. I have heard some wild stories from a lot of Homeowners. Common sense and your intuition will make you aware of anyone that you should not hire.

Disclaimer: NerdWallet strives to keep its information accurate and up to date. This information may be different than what you see when you visit a financial institution, service provider or specific product’s site. All financial products, shopping products and services are presented without warranty. When evaluating offers, please review the financial institution’s Terms and Conditions. Pre-qualified offers are not binding. If you find discrepancies with your credit score or information from your credit report, please contact TransUnion® directly.
Because of our wet/cold weather, another painter was booked out through August as of May 7th, 2016.  Anyone even thinking about a VA loan refi should get estimates for painting and pest inspections BEFORE starting on the loan paperwork, otherwise you will have difficulty getting painting and inspections done in a timely manner (and it is my understanding this is common with VA loans.)  
When I had my interior painting done, after clearing out all of the furniture, myself, I also removed all of the wall plates in all the rooms to be painted. They were a beige color and probably yellowed. The wall was originally an off white and I had it painted a light-mid grey, so those wall plates would look terrible. After pricing replacement plates, switches and outlets (Would have been way too expensive to replace all of them), I decided to just paint all of the wall plates, switches and outlets (Used just a black gloss spray paint). I sprayed the plates outside and used a small brush on the switches and outlets. It worked out just fine and the blacks plates, etc compliment the wall color. It has been 7 years and the plates, switches, outlets are holding up well.
When calculating total cost of your project, one of the most important factors to consider is the paint itself. Paint costs will be determined by the quantity of paint and primer required to complete your project, as well as the quality of the paint you choose. You can use this paint calculator to estimate how much paint you will need.. Once you have an idea what you're working with, go to your local home improvement store and compare the costs of a gallon in person. Painting professionals can also quote average prices from their years of experience working with different paint qualities.

Deciding which paint to use has gotten much easier now that acrylic latexes have pushed oil-based paints almost to extinction. The acrylics offer superior performance (they don't harden with age, the way oils do, so they move and breathe without blistering), they don't mildew as readily, and they emit fewer VOCs, so they comply with new air-quality regulations. They also work over both oil- and water-based primers.
When the primer is dry, caulk all small joints (less than ¼-inch-wide) in the siding and trim. Most pros use siliconized acrylics—paint won't stick to straight silicones—but Guertin and O'Neil like the new, more expensive urethane acrylics for their greater flexibility and longevity. O'Neil stresses that it's shortsighted to skimp on caulk. "If the joint fails, you're back to square one." Guertin uses the lifetime rating as his quality guide. "I don't expect 35-year caulk will last 35 years, but it should last longer than a 15-year caulk."
Inspect the surface area for holes, cracks or other problems and apply acrylic caulk to fill them in. Use a putty knife to smooth out the caulk and remove any excess to prevent bumps. For particularly thin or narrow crevices, you may have to use your finger to smooth out the caulk. Caulk contracts and shrinks, so apply a second layer once it's dried.

O'Neil patches shallow holes and divots with Ready Patch because it dries fast, sands smooth, and stays flexible. Deep cracks and rotten spots are best repaired with two-step epoxies, such as those made by Advanced Repair Technology. (For a step-by-step instructions, see Repairing Rot with Epoxy.) The days of using polyester auto-body fillers on wood are over. "They cure too hard," says Portland, Oregon–based painting contractor Kathleen George. "They look good at first, but then they peel away."
I was taught to paint by a professional and when estimating the amount of paint needed, I always allow for a second coat just to make sure of coverage. We interviewed a painter who tried to tell me I bought poor quality paint without knowing where I purchased it, and stated he would have to buy all new paint. He had not seen the cans and was just guessing so I asked him where I should buy paint from now on. It was the same place I had purchased my paint and he wanted to charge me an extra 20 a gallon more than what I paid for. Needless to say, I have interviewed numerous painters and they are not all honest.

Over the past year I have had several jobs given to 2 Angie's list recommendations and 1 not from a recommendation. They all have one thing in common, lack of sufficient and correct preparation to save time, labor, and the fact that they put a person in charge that was a cut corners type of worker. The two from Angie's list sent worker/s back to try touch up problems, but once the job is not prepared correctly in the first place any extra work is like putting a band-aid on a dirty wound.
Generally speaking, based on either personal experience or simply what you have heard, do painters have an outstanding reputation? Rightfully so – answering honestly and without elaborating, most homeowners, builders and property managers would likely say no. As a consumer that is familiar with some painter’s reputation – if you overlooked the importance of conducting extensive research by not asking qualifying questions and getting the proof – what would you say your chances are of having a bad experience? Obviously, pretty likely! Right? 

Painting the exterior of your house is about more than just curb appeal. The right paint provides a protective layer between your home and the elements, preventing costly damage to siding, trim and other materials. With proper prep work and the right paint for the job, you can expect your home’s paint job to look great and stand up to the conditions for several years.
Before we start, you will have to choose your color. If you would like to replicate a color already on your wall, you can use an old can of paint for reference, or you can take a chip to the paint store. We can help you identify the color, the finish, and type of paint with our visualizer tools, and we also offer a Color Consulting Service if you need help coming to a decision.
Lap marks are those ugly stripes caused by uneven layers of paint buildup. They occur when you roll over paint that’s already partly dry. (In warm, dry conditions, latex paint can begin to stiffen in less than a minute!) The key to avoiding lap marks  when doing DIY wall painting is to maintain a “wet edge,” so each stroke of your roller overlaps the previous stroke before the paint can begin to dry.
A fresh coat of paint makes everything it touches seem brand new. But such new beginnings cost real money. Professional painters charge around $4,000 for labor and materials to paint the exterior of a 2,500-square-foot, two-story home and roughly $5,500 for the interior. Painters’ rates may range from $20 to $60 an hour, but around $40 is typical in urban areas.
Oh, where to begin? Let me start with 'watered down paint'. 25-50% before the material gets to the site? Impossible. You would basically be painting with water at that point. It would be less of a hassle, and cost, to simply use proper material. You would be forced to apply three coats instead of two, as the coverage would be horrible. Whatever cost you think might be saved in materials would be lost in labor.
Hi Donnie, Thanks for your comment! We would be happy to help you connect with a fencing pro to give you an estimate on your project. You can submit a request to our pros here: www.homeadvisor.com, browse a list of local pros here: http://www.homeadvisor.com/c.html, or send your info to [email protected] and a project advisor will reach out to assist you. –HASupport
When their bids are successful, contractors meet customers to finalize their requirements and plan the order and timing of work. Contractors estimate the time required for surface preparation, painting several coats and drying time between coats. For interior painting jobs, they might have to allow time for clearing rooms. Exterior painting schedules might be dependent on the weather in different parts of the country. Exterior painting is not practical in very wet or very cold conditions.
The materials of the home’s facade should be considered before painting your home. When painting flat surfaces like siding or wood, you can opt for standard outdoor paint. When painting a textured surface like stucco or brick, “elastomeric” paint is a much better choice. This type of paint can stretch more than normal paint, which allows it to bridge over small gaps and crevices, painting smoothly over texture.

Home and business owners alike know that the professionals of Southern Painting are the best painters in Fort Worth to trust. Not only are our painters bonded and insured – we also back our work with a transferrable Three-Year Limited Labor Warranty. Combine that with over 28 years of experience, and there’s simply no reason to go anywhere else. We provide services above and beyond what you can do yourself, and we go further for our customers than any of the other painters Fort Worth has to offer.
If you decide to hire help, have several contractors inspect the job and provide proposals. You'll probably find huge price differences for the same job. A Checkbook undercover shopper got quotes from nine Washington-area contractors to repaint the walls, ceiling and trim for a living room, dining room, family room, bathroom and kitchen. Including paint and supplies, prices ranged from $2,650 or less to more than $6,500.
At Five Star Painting, we offer free price estimates, so there’s no reason to hesitate! Our house painting contractors know what they’re doing, and they do it well! Call our residential painting experts today at (888) 261-3633 to receive your free estimate or to schedule a home visit. Use our online scheduler to pick the date and time of your consultation.
Concrete walls must always be prepared before painting, but in some cases previous finishes will also have to be removed so that paint doesn't peel or chip off. Additionally, special sealants, primers and paints may be applied to ensure concrete's endurance in face of the specific elements. Depending on the wall's condition and exposure to the sun, painting professionals will usually estimate between $500 (~250 sq. ft.) and $2,000 (~1,000 sq. ft.), depending on wall area to cover.
I am in northern Nevada and you have not yet gotten sufficient responses to provide a painting cost chart showing the averages.  I do have a quote from an outside (Not Homeadvisor referral) painter who is local for $2,750 for soffits, patio cover and posts, Garage facia (redwood clapboard above (~300 ? Sq. Ft.) on a 2046 Sq. Ft. home where the walls are 9 ft tall and it is fully stuccoed with plastic stucco surfaces, so not being painted.   

The best time to tackle windows is in the beginning of the day, when you're fresh," says Doherty. "But it still takes me an hour to do a standard window." For double-hungs, begin by raising the inner sash and lowering the outer sash until their positions are almost reversed. Paint the lower half of the outer sash first, then the entire inner sash. Once the lower sash is dry, return both to their normal position, but leave them slightly open. Finish painting the outer sash. "Windows take too long to tape," says Doherty. When painting, overlap the glass by 1/16 inch to seal the wood.
"I had called the last minute for an interior painter, because I had flown into town for just 5 days, to get my home painted. PPP Paint Services made time for me. Made an appointment on a Monday and they were there by Thursday and done by Friday. 9 rooms including trim work. The job came out great, and at a great value. I would highly recommend this company."
Day-to-day tasks can consume too much time when there is little or no automation. Countless cloud-based productivity tools are available to streamline and automate your tasks. These tools can usually be put into place with little disruption to your current practices. Ultimately, integrating new automation tools will increase productivity and help you make the most […]
As a former professional painter, something that drives me crazy is when I see painters cut in around wall plates. First of all, the amount of time that it takes to cut in is usually much longer than the amount of time that it takes to simply remove the wall plate. Secondly it does not look nearly as clean as it does when the wall plate is removed and thirdly it can invariably leave paint on the wall plate itself which also looks sloppy. Make sure the painter takes them off and then reinstalls them. It's less time.
Buying a can of premium paint, then bait and switch over to low-line products? Again, complete nonsense. Think about it for a moment; the Painter needs 5 gallons of wall finish. So, he buys one can of premium and the rest 'cheap'? How is he going to hide the 4 other gallons? What's he going to hide it in??? He only has ONE gallon of premium. It's not as though he's going to keep older can labels, they would be covered in paint of a different colour.

Colorado Painting Company

×