Every painting job develops a unique choreography as ladders go up and come down and tarps are unrolled and folded up. But two basic principles remain: 1) Start at the top and work down. 2) Work in the shade, out of the sun's glare. As the dance proceeds, keep an eye on the weather. Rain can wash freshly applied latex right off the wall, and a temperature dip below 50 degrees F two days after application can interfere with adhesion and curing and dull the sheen of glossy paints. (Latexes like Sherwin-Williams's Duration and Benjamin Moore's MoorGard Low Lustre are formulated to tolerate temps as low as 35 and 40 degrees, respectively.)

A fellow (actually lives in the same neighborhood) by the name of Wayne Hickey (843-655-0366) painted the ceilings and most of the walls of our house in February 2017. He got paint all over my light fixtures, all over my trim around the doors, and had visible lap marks everywhere on the walls. He came back and rectified some of the problems, but not all, as I have noticed as I have had time to look more carefully at the work he and his assistant did. His assistant had no idea (not a clue) how to roll paint on a wall or ceiling. Some places were not covered. He said he would pull nails for pictures and then re-insert the nails exactly where they were. This he did not do as he promised. He painted over the nails. His assistant had no idea how to use a paint roller. I have painted all my life, and would have done this work myself, but I just had a full knee replacement and the other knee is in bad shape. I just could not do the work. Wayne is a pleasant and congenial individual, but he can not cut in a ceiling or wall to my satisfaction - not even close. He should have a putty knife and wet cloth with him all the time to correct any paint that might get applied where it shouldn't. That is something I always did as a painter. I would not recommend Wayne to paint anybody's home.
For interior paint I prefer the semi-gloss, provides a very subtle sheen and is super easy to clean -no flaking, chipping, etc. I've painted a lot, and found that Sherwin Williams Ovation paint has been the easiest to use, and provides the best coverage. I even painted my ceilings with it and WOW! I was done it no time at all, with perfect coverage.
I am very pleased with this book. I think it has very good information. It seems to be written by an expert and I wanted expert advice. I know it is an older book, but I think his knowledge is very helpful. I needed advice. I have had work done on my house that did not work out well, so I needed to try to inform myself. I think this book has been very helpful.

Small random-orbit or pad sanders make this job go faster. (Wallis first covers these boundaries with Synkoloid patching compound so no edge is visible after sanding.) As shown, you want to make sure that there is a feathered, smooth transition from exposed wood to old paint. For areas that might get close scrutiny, you can follow up with a 100- or 120-grit rubdown to erase any scratches.
The last big decision is how to apply the paint. Most pros use paint sprayers because they're fast, but in inexperienced hands a high-powered sprayer can leave drips, thin coats, and a mist that may land on many things other than your siding. If you do hire a painter who uses a sprayer, make sure he is meticulous about removing, covering, or masking off everything in the area that might get hit with overspray: gutters, roofs, windows, shrubbery, walkways, cars—you name it.
Painting the exterior of your home is an essential maintenance task that can be challenging, time-consuming and extremely messy. The fastest and safest way to get the job done right is to hire a professional exterior painting contractor. A pro will have the right tools, equipment, and experience for the job, will be able to recommend the most effective paints for your particular project, and can handle the necessary prep work to ensure a lasting finish. They will also select the best time to paint your home to keep the project within your timeline and budget.
In England, little is known of the trade and its structures before the late 13th century, at which paint guilds began to form, amongst them the Painters Company and the Stainers Company. These two guilds eventually merged with the consent of the Lord Mayor of the City of London in 1502, forming the Worshipful Company of Painter-Stainers. The guild standardised the craft and acted as a protector of the trade secrets. In 1599, the guild asked Parliament for protection, which was eventually granted in a bill of 1606, which granted the trade protection from outside competition such as plasterers.[2]
My wife and I just painted the interior of our house with about 6-8 gallons, of $30+ per gallon (meaning the good stuff, non-diluted) with absolutely fantastic results. However we just paid an average of $5 per gallon. Reason...all big box stores have paint, set aside, that has been mixed but not picked up by the customer. They need to sell it quick and if you're not in a hurry (you know well in advance that a room or two need painting and it's not like the roof leaking and needs an immediate fix) you can go to each store when you need other supplies or food, like Walmart (when convenient, driving 20 miles to each is not worth it) and over the course of a month or two, pick out some very nice colors of quality paint. We found perfect colors...not saying they were our first choice but when we opened the can, very nice and some even better than our original picks. Cost to paint the entire house was about $100, with all materials included, period. We had it on the market for a few months to sell, didn't sell, painted the rooms, got 2 offers the day after we finished, took the best one and never looked back.
Day-to-day tasks can consume too much time when there is little or no automation. Countless cloud-based productivity tools are available to streamline and automate your tasks. These tools can usually be put into place with little disruption to your current practices. Ultimately, integrating new automation tools will increase productivity and help you make the most […]
One of the most popular painting applications in the industry, ColorSnap suggests colors that will work in at your job site. Simply take a picture of the room, entryway or whatever else, and the software will find up to eight colors that will create a beautiful space. In addition, the program will suggest coordinating colors and help you locate the nearest Sherwin-Williams store.
to be the devils advocate i have been a building contractor 20 of the last 30 yrs. i do know that if you go to a higher sheen of paint and or darker colors then any imperfections in the walls will show up much more dramatically…therefore the painter or a good drywall finisher is needed to prepare the walls extensively. this could cause more expenses…for it takes a lot of time to prep walls (smooth walls..not textured walls) and this cost has to be absorbed.

The pros were split on this tip. "Masking tape is problematic," says Mark Dixon, a painter in Missoula, Montana, and author of "House Painting Inside and Out" (Taunton Press, 1997). "Paint can bleed behind the tape, or remove the paint it's stuck to." Another problem is bridging. "Latex paints form a skin," says Dixon. "Removing painted tape can tear the skin, resulting in a ragged rather than a sharp line." Lastly, taping takes time. "Learning how to cut in with a brush takes practice, but if you can do it, you'll leave most tapers in the dust," Dixon says. (Cutting in is painting just the surface you want, not the surface adjacent to it — for example, where a wall meets the ceiling.) On the other hand, "If you can't cut in, you can't beat tape," says Span. The pros we spoke with all recommend painter's (blue) tape because it's easier to remove than masking tape. To prevent bleeding, Span uses a putty knife to bed the tape. After letting the paint dry, he scores the edge of the tape line with a utility knife to avoid tearing the paint.
At Supreme Painting, our goal is to provide exceptional quality interior and exterior, residential and commercial painting services. We strive to provide these services in the most timely manner, and with an ongoing comprehensive quality control program.  If you want the best residential house painter or commercial painting contractor, you can count on Supreme Painting.
Before the scrubdown, protect nearby plants by misting their leaves and saturating the surrounding soil with water, pulling them away from the house, and shrouding them in fabric drop cloths. (Plants will cook under plastic.) Lay more drop cloths along the base of the walls to collect any falling paint debris. Walls should be wet down before getting scrubbed, then washed with a gallon of water mixed with 1 cup chlorine bleach and 1 cup of either a concentrated, phosphate-free cleaner, such as a trisodium phosphate (TSP) substitute, or Jomax House Cleaner. Working in sections, from the bottom to the top, will avoid streaks. Be sure to rinse walls well before the solution dries. Wood siding and trim should be ready to paint after a day or two of dry weather.
Before the scrubdown, protect nearby plants by misting their leaves and saturating the surrounding soil with water, pulling them away from the house, and shrouding them in fabric drop cloths. (Plants will cook under plastic.) Lay more drop cloths along the base of the walls to collect any falling paint debris. Walls should be wet down before getting scrubbed, then washed with a gallon of water mixed with 1 cup chlorine bleach and 1 cup of either a concentrated, phosphate-free cleaner, such as a trisodium phosphate (TSP) substitute, or Jomax House Cleaner. Working in sections, from the bottom to the top, will avoid streaks. Be sure to rinse walls well before the solution dries. Wood siding and trim should be ready to paint after a day or two of dry weather.
Using the right software makes your job much easier and helps you get the best possible results. You can easily find the right paint combinations to please your client and quickly order the paint from a nearby store. A good field service management application, such as mHelpDesk, allows all departments of your business to smoothly coordinate their efforts, eliminating wasted time and producing happy customers.
Paint gets more expensive as you go from flat to gloss. The difference is usually around $1 per gallon per sheen upgrade. Flat is the cheapest, then matte flat or eggshell, satin, semigloss then gloss. Paint also gets much more expensive the darker it gets. A white or neutral paint color can be as much as $20 less expensive than a deep base red or blue.
"Cutting in is an acquired skill, but it's something you can't do at all with a ratty brush," says Doherty. When cutting in on a wall, he loads his brush and spreads out the excess paint, then works the brush up to the line between wall and ceiling. A brush stroke that's too wide creates a hatband, or smooth brushed band, on the very top of the wall where it meets the ceiling. To avoid this, Dixon recommends rolling first and then cutting in with a brush. "A good roller can get within 1/2 inch of the ceiling," he says. "You'll save time by not brushing more then you have to." When painting baseboards, "a wide taping knife makes a good paint guard," says Span. "Just keep the blade clean to prevent drips from working around the edge of the knife."
To maintain a wet edge, start near a corner and run the roller up and down the full height of the wall, moving over slightly with each stroke. Move backward where necessary to even out thick spots or runs. Don’t let the roller become nearly dry; reload it often so that it’s always at least half loaded. Keep the open side of the roller frame facing the area that’s already painted. That puts less pressure on the open side of the roller, so you’re less likely to leave paint ridges when doing DIY wall painting.

This article with comments was terrific - it was so informative. I found the advice useful. It addressed specifics like the condition of the dry wall surfaces, any additional repairs such. pin holes, chalking, smoothing of wall surfaces, absorption of paint and number of coats that may be needed. It should also include insurance coverage, and reflect the clean-up afterwards. Having a written contract with the company's letterhead is a must.


In general, glossier paints are more stain-resistant and scrubbable. But a higher sheen also highlights any imperfections in the wall or in the paint job. "Flat paints are fine for ceilings and formal rooms, but for most of my customers, I recommend an eggshell gloss. It's good for hallways, kids' rooms, even kitchens and baths," says Toto. It seems that latex paints have won over even the most finicky painters. "Though we still use oil-based paints for restor-ation work, latex paints are fine for interior walls and new trim," says Toto, "as long as you don't go cheap on the paint." All of our pros have their personal favorites, but they agree that good paint does not come cheap. "You'll spend $20 to $35 per gallon for a top-shelf paint," says Weeks. The pros also agreed that using two coats of paint will result in the best-looking job. Don't skimp on the coverage; if you're covering more than 400 square feet per gallon, you're spreading it too thin. Also, keep 1/4 to 1/2 gallon on hand for touch-ups.
Paint will be your next-biggest cost, at anywhere from $20 to $70 or more per gallon, depending on the sheen, the grade you’ve chosen and any special features. Some paints, for instance, are mold resistant. Others suppress smells or require fewer coats. Some have a lifetime warranty. Paints with warranties, however, may not be worth a higher price. In Consumer Reports tests approximating nine years of wear, only a few exterior paints and stains with lifetime warranties held up well. But “you’ll grow tired of the color long before a good-quality paint wears out,” Bancroft says.
To get basic measurements, measure the length and width of each wall you want to paint in inches. Multiply the length and height together, and divide by 144. This will give you the square footage for each wall. A gallon of paint typically covers around 400 square feet. In some cases, you may need a primer 2 first, then a single coat of paint, meaning that you may need one gallon of primer and one gallon of paint to cover 400 square feet. However, if the wall requires multiple coats, this will increase the total amount of square footage required, and therefore the amount of paint.
If you have ornamental or colorful trees, shrubbery or floral selections around your home you should figure their colors into the color scheme selection that is made.  These landscaping attributes will have an effect on how appealing the property is as a whole throughout the year.  Homes that have a great deal of trees can make the property darker and cast shadows onto the home.  Individuals will want to avoid darker colors for these situations.
×