Deciding which paint to use has gotten much easier now that acrylic latexes have pushed oil-based paints almost to extinction. The acrylics offer superior performance (they don't harden with age, the way oils do, so they move and breathe without blistering), they don't mildew as readily, and they emit fewer VOCs, so they comply with new air-quality regulations. They also work over both oil- and water-based primers.
Based in the United Kingdom, Ian Linton has been a professional writer since 1990. His articles on marketing, technology and distance running have appeared in magazines such as “Marketing” and “Runner's World.” Linton has also authored more than 20 published books and is a copywriter for global companies. He holds a Bachelor of Arts in history and economics from Bristol University.
Small random-orbit or pad sanders make this job go faster. (Wallis first covers these boundaries with Synkoloid patching compound so no edge is visible after sanding.) As shown, you want to make sure that there is a feathered, smooth transition from exposed wood to old paint. For areas that might get close scrutiny, you can follow up with a 100- or 120-grit rubdown to erase any scratches.
Ask companies to include all details in writing. Although that sounds simple enough, too many contractors submit offers such as "paint house for $5,000." A friendly contractor may offer a reassuring handshake and promise that the crew will take care of all the details — starting on time, working every day, cleaning up, etc. That's great, but why not include each point in the proposal? If it's a challenge to get a written description of labor, materials and other details, things will probably get worse when the work starts.
To maintain a wet edge, start near a corner and run the roller up and down the full height of the wall, moving over slightly with each stroke. Move backward where necessary to even out thick spots or runs. Don’t let the roller become nearly dry; reload it often so that it’s always at least half loaded. Keep the open side of the roller frame facing the area that’s already painted. That puts less pressure on the open side of the roller, so you’re less likely to leave paint ridges when doing DIY wall painting.
After painting the ceiling, work from the top down: Start with the crown molding, then do the walls and then paint the casement molding around the windows and doors. Do baseboard molding last. "Painting the baseboards last keeps dust and grit from traveling off the floor, onto the brush and then up onto the freshly painted casements," explains Weeks.
The BBB isn't a painter-specific group but rather an organization that is dedicated to ensuring that consumers can access information about anyone they do business with. The BBB also rates companies based on a Standards of Trust scale, which goes from A+ to F. A company doesn't have to be a member to get a grade, and it's a good idea to check to see how your contractor is scored as well as its membership status.
On its last day, I was listening to see how they would handle it. They brought in personalities who were friends of the station for interviews, played some popular pieces, and were set to sign off at the appointed and anointed 10 p.m. They put on a recording of Beethoven’s 9th, which for many people still holds its place as the finest piece of Western music ever composed. But what would they say afterwards? I waited to hear, and they said the classiest thing they could: nothing.
Contracting is not conducted very often. Or, is it? What about your internet or television provider? How about a restaurant? Are we not contracting a service? Other than hunger, the attraction of the food or the ambiance – ask yourself, what inspired enough interest for you to check that particular restaurant out? Maybe it was word of mouth, good reviews, a good sanitation score, a clean atmosphere, the professional service, the quality of the food, maybe being close by or locally sourced food also helped? While you were considering all these factors – little did you know – you were qualifying and researching before you chose to give that particular restaurant your business. Most dinners cost under $50 per person. Why wouldn’t we take the additional steps needed to qualify our potential contractors for projects that typically cost much more??
Most painters have no problem painting doors in place, but they recommend you lay the door on sawhorses and work horizontally. If you have a paneled door, start with the panels and work from the outside edges in toward the center. "Watch the corners — paint loves to puddle," warns Dixon. While the paint is still wet, lightly "tip off" the panel with an almost dry brush. (Tipping off is pulling the brush over the surface to level out the finish.) When painting the stiles (vertical) and rails (horizontal) just follow the grain of the wood. When the grain changes abruptly, for instance, where the rail meets the stile, don't stop your brush stroke — you'll only leave a lump of paint. Apply paint across the joint with a full stroke, and then tip off the overlapping section by pulling the brush in the direction of the grain. "Make sure the door is dry before painting the opposite side or rehanging it," says Maceyunas.
If your home was built before 1978, there is a good chance that lead paint was used in its construction. Scraping, sanding, or removing old paint can release toxic lead dust which can cause serious illness in children and pregnant women. Special handling is required when working with lead-based paints. If lead paint is present in your home, you will need to hire a lead-certified painting contractor or lead abatement contractor. Before getting started with your exterior painting project, consult your local building authority or visit www.epa.gov for more information.
The article and comments were great information to have before deciding how to go about getting a painting job done. I think the important point is that there are several key choices (who to do the work; color, sheen, quality, of paint; how many coats; amount of prep/repairs to be done and by whom, how long the job will take, provisions for changes, how detailed the contract needs to be; advanced deposit/progress payments/final payment; final inspection, etc.) that need to be made and it requires advanced research and planning in order to become well enough informed to make the right choices. Then it requires spending sufficient time to check materials and inspect the quality of the work while it is on-going, raher than waiting to do it all at the end. President Reagan's philosophy of "Trust, but verify." applies.
One of the fastest, most effective ways to personalize your living space is with color. Bright, muted, cheerful, elegant—whatever your mood, personality, or preference might be, there’s a paint color to match! Our local Five Star Painting teams specialize in making houses feel like homes through interior and exterior home painting services. If you're looking to transform your home, it's time to contact Five Star Painting. Call (888) 261-3633 for a free estimate, or schedule an appointment online. Let us help you paint your world!
I do not mean to come off with an edge, however, this is an article for people hiring low bid, uninsured, one man band painters out to "hustle" a buck. Hire reputable, established companies or hire someone you know or have a strong referral from. If you are arguing over watered down paint, ticky, tacky deposits, buying your own supplies, you have hired the wrong guy.
Repaint — exteriors especially — before visible signs of wear appear, Bancroft says. Don’t wait until you see peeling or flaking paint. “If I have to spend 40 hours preparing the surface before we can paint, that time is going to result in a lot of extra costs. But if I can spend 10 hours preparing the surfaces to be painted, you’re going to save money,” Freeman says.
I am in northern Nevada and you have not yet gotten sufficient responses to provide a painting cost chart showing the averages. I do have a quote from an outside (Not Homeadvisor referral) painter who is local for $2,750 for soffits, patio cover and posts, Garage facia (redwood clapboard above (~300 ? Sq. Ft.) on a 2046 Sq. Ft. home where the walls are 9 ft tall and it is fully stuccoed with plastic stucco surfaces, so not being painted.