Thorough preparation is essential to ensure a good finish. Contractors might have to fill cracks or holes and remove old paint if it is badly worn, peeling or flaking. They remove all paint and apply a suitable primer to the bare surface. If the existing paint is in reasonable condition, they clean it and rub it with abrasive material to provide a key for the new paint. On new surfaces, such as bare wood or fresh plaster, they apply a suitable seal, followed by a primer coat.
Using the right software makes your job much easier and helps you get the best possible results. You can easily find the right paint combinations to please your client and quickly order the paint from a nearby store. A good field service management application, such as mHelpDesk, allows all departments of your business to smoothly coordinate their efforts, eliminating wasted time and producing happy customers.
O'Neil patches shallow holes and divots with Ready Patch because it dries fast, sands smooth, and stays flexible. Deep cracks and rotten spots are best repaired with two-step epoxies, such as those made by Advanced Repair Technology. (For a step-by-step instructions, see Repairing Rot with Epoxy.) The days of using polyester auto-body fillers on wood are over. "They cure too hard," says Portland, Oregon–based painting contractor Kathleen George. "They look good at first, but then they peel away."
Project management is important for contracted painting jobs because it helps with communication and lowers the chance of complaints. The fact is, contracting is the #1 source of consumer complaints in the state and project management is what triggers most calls to the State Contractor’s License Board and the Better Business Bureau. With a proper project management system in place, these complaints can be avoided and your job will be completed the right way.
Second: all the tricks of the trade in regard to "cheating" customers is for hustlers and cheaters and NOT established businesses. At the end of the project the job should come out looking professionally painted as specified in the contract. A selected color that takes multiple coats that was not calculated by the contractor should cost more money. It's not the fault of the painter.
Repaint — exteriors especially — before visible signs of wear appear, Bancroft says. Don’t wait until you see peeling or flaking paint. “If I have to spend 40 hours preparing the surface before we can paint, that time is going to result in a lot of extra costs. But if I can spend 10 hours preparing the surfaces to be painted, you’re going to save money,” Freeman says.
This all comes down to the rules.....1. references....does the contractor have them??? I ALWAYS furnish all my prospective customers them....no excuses...2. insurance....again, I always furnish proof....3. Read the proposal carefully...I ALWAYS list materials down to tape used, the brand, the grit of sandpaper, the manufacturer, etc....its INEXCUSABLE to not list all of these items....I am a member of the PDCA, the Painting and Decorating Contractors of America, the foremost authority in the coatings industry and they also approve of what I listed....if you do not follow these guidelines, you will NOT get a job reflective of "professional". Look for the PDCA where any painting contractors are, if they are not a member, RUN!
I agree with JHs. If there is no new color on it at all, just talk to the painter about it, if it was an honest mistake (which can happen very easily while painting) your painter should have no problem fixing it. However, in my years of experience, it is not unusual for 2 coats of door paint (good quality) not to cover very well at all. I once painted a red door 7 times, plus a tinted prime coat before I found the door to be a solid color.
The last big decision is how to apply the paint. Most pros use paint sprayers because they're fast, but in inexperienced hands a high-powered sprayer can leave drips, thin coats, and a mist that may land on many things other than your siding. If you do hire a painter who uses a sprayer, make sure he is meticulous about removing, covering, or masking off everything in the area that might get hit with overspray: gutters, roofs, windows, shrubbery, walkways, cars—you name it.
Safest way to ensure that everything is fair is to get it ALL in writing , signed by both parties. Specify each item that needs repair. Also, BUY the paint YOURSELF. That way, there is no incentive to water it down, and you KNOW that you are getting the grade/quality you actually purchased. Don't be penny wise and pound foolish; if you are paying to hire a painter, buy the best paint that you can afford, to ensure maximum life of this home improvement.
The materials of the home’s facade should be considered before painting your home. When painting flat surfaces like siding or wood, you can opt for standard outdoor paint. When painting a textured surface like stucco or brick, “elastomeric” paint is a much better choice. This type of paint can stretch more than normal paint, which allows it to bridge over small gaps and crevices, painting smoothly over texture.
I did go with the highest bidder and it did not matter. They did a shoddy job and threatened to take me to court when I pointed out mistakes that they made based on their work standards stated on the quote. I have not paid them yet, just filed a complaint with the BBB. No money down asked, no contract signed. The boss stated I have to high of expectations just because I live in a 121 year old house!
Hi Elaine, We would be happy to get you connected with a painting and wallpaper pro. You can submit a service request on our website: http://www.homeadvisor.com/ or browse reviews for local pros here: http://www.homeadvisor.com/c.html. We can also have a project advisor reach out to assist you if you send your contact information to [email protected] –HASupport
Professional painters provide estimates primarily based on the square footage of your home. Painting an average home between 500 and 1,500 square feet can cost between $1,000 and $3,000. However, factors such as number of stories and ease of access can also affect the overall price. Homeowners report that the average cost to paint a house nationally is $2,581 and most pay between $1,714 and $3,682.
Pros prefer 5-gallon buckets with a roller grid to roller pans. They hold more paint than pans and, says Doherty, "It's tougher to tip over a bucket." A bucket also lets you box, or mix, two or three cans of paint to avoid color discrepancies. To use a bucket and grid, dip the roller a quarter of the way into the paint and run it over the ramp to work the paint into the nap.
Buying a can of premium paint, then bait and switch over to low-line products? Again, complete nonsense. Think about it for a moment; the Painter needs 5 gallons of wall finish. So, he buys one can of premium and the rest 'cheap'? How is he going to hide the 4 other gallons? What's he going to hide it in??? He only has ONE gallon of premium. It's not as though he's going to keep older can labels, they would be covered in paint of a different colour.