"Modern paints dry too quickly, and are difficult to brush out," says Dixon, who uses paint additives, such as Floetrol for latex paints and Penetrol for alkyds. "Adding a few ounces per gallon slows drying time and makes the paint more workable," he says. Another problem is bridging. "Latex paints form a skin," says Dixon. "Removing painted tape can tear the skin, resulting in a ragged rather than a sharp line." Lastly, taping takes time. "Learning how to cut in with a brush takes practice, but if you can do it, you'll leave most tapers in the dust," Dixon says. (Cutting in is painting just the surface you want, not the surface adjacent to it — for example, where a wall meets the ceiling.) Although there are mildewcide additives, our pros prefer using bathroom and kitchen paints that have built-in mildew fighters. "These paints will prevent mildew from forming, but they won't kill mildew that's already there," Dixon points out. Because leftover mold spores can live beneath the paint and eventually work their way through to the surface, you should also prep bath and kitchen surfaces. First, wash down the walls with a bleach solution (3/4 cup of bleach per gallon of water) then seal with a stain-blocking primer, such as Zinsser's Bulls Eye 1-2-3 or Kilz's Total One.
In England, little is known of the trade and its structures before the late 13th century, at which paint guilds began to form, amongst them the Painters Company and the Stainers Company. These two guilds eventually merged with the consent of the Lord Mayor of the City of London in 1502, forming the Worshipful Company of Painter-Stainers. The guild standardised the craft and acted as a protector of the trade secrets. In 1599, the guild asked Parliament for protection, which was eventually granted in a bill of 1606, which granted the trade protection from outside competition such as plasterers.
For most people, their home is their most valuable asset and that’s why it needs to be painted exclusively by professionals. Think about it; you wouldn’t paint your car, so why would you consider painting your home? Rather than putting your most valuable asset at risk, not to mention your own safety and well-being, trust the Fort Worth painters of Southern Painting to get the job done quickly, safely, efficiently and properly.
In general, glossier paints are more stain-resistant and scrubbable. But a higher sheen also highlights any imperfections in the wall or in the paint job. "Flat paints are fine for ceilings and formal rooms, but for most of my customers, I recommend an eggshell gloss. It's good for hallways, kids' rooms, even kitchens and baths," says Toto. It seems that latex paints have won over even the most finicky painters. "Though we still use oil-based paints for restor-ation work, latex paints are fine for interior walls and new trim," says Toto, "as long as you don't go cheap on the paint." All of our pros have their personal favorites, but they agree that good paint does not come cheap. "You'll spend $20 to $35 per gallon for a top-shelf paint," says Weeks. The pros also agreed that using two coats of paint will result in the best-looking job. Don't skimp on the coverage; if you're covering more than 400 square feet per gallon, you're spreading it too thin. Also, keep 1/4 to 1/2 gallon on hand for touch-ups.
Disclaimer: NerdWallet strives to keep its information accurate and up to date. This information may be different than what you see when you visit a financial institution, service provider or specific product’s site. All financial products, shopping products and services are presented without warranty. When evaluating offers, please review the financial institution’s Terms and Conditions. Pre-qualified offers are not binding. If you find discrepancies with your credit score or information from your credit report, please contact TransUnion® directly.
Interesting information! We just got scammed in White Stone, Virginia... we chose the same color, but went from a flat to an eggshell finish. I wasn't available to stand over the painter while he painted. For such a detailed job, I marveled at how quickly he finished the project! After he was paid for the job, we discovered all he did was roll paint across the walls and close to the crown, baseboards and detailed trim around windows and doors leaving about an inch or so of the flat finish. By using the same color, he didn't even do the job he was paid to do, which explained why he could finish the job so quickly. By using the same color... he got lucky and passed it off as a completed job not bothering to paint to and cut in around the trim. Upon further evaluation of our walls we could see exactly where he stopped because we could see the difference between the flat and eggshell finishes. There are walls he didn't even bother to paint. Then where he did paint near the crown when we were in the room watching ... he hit the crown moulding and tried to tell us it was already there... and tried to sell us on painting the crown moulding. I am so disgusted and upset!! He'll be hearing from us to rectify the situation.
As you walk through your lighted rooms (preferably day light) see if the new coat has light spots showing the precious paint. This is call "bleeding through". This means that there's only one coat of paint or the paint was diluted or the trasition of colors were from light to dark (or the other way around) and primer was not use or the painter is inexperienced.
I'm an architect and my firm routinely specifies interior finishes for projects so I thought I'd contribute a professional's perspective on the issue of how many coats of paint are deemed "acceptable". The fact of the matter is the average consumer usually isn't a paint expert and can't be expected to know about all the factors that impact coverage. That knowledge is considered "means and methods" and in a court of law, the responsibility lies with the painter or general contractor, not the consumer. What the consumer should be concerned about is the final result-does it look good and is it what you expected? The simplest way to communicate this to your painter is to stipule in your written agreement that the number of coats will be "as required to cover". That way all the guess work about what kind of primer, how many coats, how color affects the scope of work, etc., is removed from the consumer's responsibility and resides where it belongs-with the professional. In the contract that's why retention is always a good idea-typically 10% is withheld from payment until the job is completed to the satisfaction of the customer. Of course in return you as the customer have to be reasonable about what constitutes a completed job. Just my $.02.