I made the HUGE mistake of hiring Certa Pro to do several interior rooms of my house, and remove popcorn ceiling in a bathroom. What a nightmare! They didn't paint any door jams, they broke a cedar window sill-and didn't bother telling me, they gouged a hardwood floor, they never sealed the room that had the popcorn removed--causing white powder to be in all rooms of a 2 story home. I can go on and on. Horrible company


The only time it's acceptable to mix water in the paint is when you're using a deep or ultra deep base paint to reduce its stickiness, which is rare with new paint technology. Dark primary colors are composed almost entirely of tint that makes it very hard to work with without adding water. (You never use a sprayer and need to thin paint.?) If i was still in the industry I'd take the time to make a better article than this. Take this for a grain of slat. Use a reputable painter or someone you know you can trust or has been referred to you by someone you trust. I wouldn't hire anyone I had to watch like a hawk to make sure they're not screwing me.
This article with comments was terrific - it was so informative. I found the advice useful. It addressed specifics like the condition of the dry wall surfaces, any additional repairs such. pin holes, chalking, smoothing of wall surfaces, absorption of paint and number of coats that may be needed. It should also include insurance coverage, and reflect the clean-up afterwards. Having a written contract with the company's letterhead is a must.
If you paint over dirty, oily surfaces, the paint will easily chip or peel off. So before painting, clean grimy areas with a deglosser or heavy-duty cleaner intended for prepaint cleaning. They work well to clean painted, varnished or enameled surfaces to improve the adhesion of the new paint. They’re ideal for cleaning greasy or oily areas like kitchen and bathroom walls and removing hand marks around light switches and doorknobs.
This article with comments was terrific - it was so informative. I found the advice useful. It addressed specifics like the condition of the dry wall surfaces, any additional repairs such. pin holes, chalking, smoothing of wall surfaces, absorption of paint and number of coats that may be needed. It should also include insurance coverage, and reflect the clean-up afterwards. Having a written contract with the company's letterhead is a must.
Filling gaps with a paintable acrylic-latex caulk cuts down on drafts and makes your trim look better than new. The secret to using caulk is to cut the tip smaller than you think it should be; too much caulk makes a mess. Also, instead of using a nail to break the inner seal, use a small wire so you don't stretch out the nozzle. Also consider buying a dripless caulk gun, which will automatically back off the pressure after each pull on the trigger to prevent unwanted oozing.
• One room or the whole house? Applying one coat in one room is a reasonable DIY Saturday project (especially if you have help and beer). Multiply the time spent moving furniture, prepping walls and sanding old trim by the number of rooms in the house, and you might want to hire real help. It's the same outside. You can probably tackle one shady garage wall that needs a little scraping and sanding plus a coat of paint, but covering all surfaces of the house is usually best left to a pro.
The companies with the best paint products are Benjamin Moore, Dunn Edwards, Sherwin Williams, and Vista Paint. As a painter I don't recommend Berh from Home Depot as much because it's quality is just marketing. Flat paint has no sheen and it shows its true color, but is not easy to wash or clean. Satin, eggshell have low sheen and is washable. Semigloss ang glossy has a high sheen and these paints are recommended for bathrooms and kitchen or where there's high humidity and steam.

The perfect roller would hold a roomful of paint, leave the right amount of texture, wouldn't spray or fuzz, and would be easy to clean. Until somebody invents the ideal one, follow these tips to choose the right roller. "The longer the nap, the more paint the roller will hold, but it will also create more texture." says Dixon. "A 1/2-inch nap lamb's-wool roller holds plenty of paint without too much texture," says Dixon. "Less expensive rollers can work," says Span. "Just wash them first in dishwashing liquid to remove any stray fibers." Most of the pros we spoke with prefer 9-inch rollers over 18-inch models -- they are lighter, cheaper, and easier to use. Despite these shortcomings, Maceyunas swears by the wider roller. "The roller can do a whole wall in a few up and down strokes instead of in several dozen W and M strokes," he says.

Using the right software makes your job much easier and helps you get the best possible results. You can easily find the right paint combinations to please your client and quickly order the paint from a nearby store. A good field service management application, such as mHelpDesk, allows all departments of your business to smoothly coordinate their efforts, eliminating wasted time and producing happy customers.
Painting contractors must also carry out administrative and marketing duties. They prepare final accounts for customers based on the original estimates and any additional work. They analyze the cost of the job compared with the estimate to calculate their profit. They market their business through activities such as setting up websites, asking customers for references or contacting property maintenance companies with details of their services.
I agree with JHs. If there is no new color on it at all, just talk to the painter about it, if it was an honest mistake (which can happen very easily while painting) your painter should have no problem fixing it. However, in my years of experience, it is not unusual for 2 coats of door paint (good quality) not to cover very well at all. I once painted a red door 7 times, plus a tinted prime coat before I found the door to be a solid color.
The best time to tackle windows is in the beginning of the day, when you're fresh," says Doherty. "But it still takes me an hour to do a standard window." For double-hungs, begin by raising the inner sash and lowering the outer sash until their positions are almost reversed. Paint the lower half of the outer sash first, then the entire inner sash. Once the lower sash is dry, return both to their normal position, but leave them slightly open. Finish painting the outer sash. "Windows take too long to tape," says Doherty. When painting, overlap the glass by 1/16 inch to seal the wood.
Deciding which paint to use has gotten much easier now that acrylic latexes have pushed oil-based paints almost to extinction. The acrylics offer superior performance (they don't harden with age, the way oils do, so they move and breathe without blistering), they don't mildew as readily, and they emit fewer VOCs, so they comply with new air-quality regulations. They also work over both oil- and water-based primers. 

• One room or the whole house? Applying one coat in one room is a reasonable DIY Saturday project (especially if you have help and beer). Multiply the time spent moving furniture, prepping walls and sanding old trim by the number of rooms in the house, and you might want to hire real help. It's the same outside. You can probably tackle one shady garage wall that needs a little scraping and sanding plus a coat of paint, but covering all surfaces of the house is usually best left to a pro.


In England, little is known of the trade and its structures before the late 13th century, at which paint guilds began to form, amongst them the Painters Company and the Stainers Company. These two guilds eventually merged with the consent of the Lord Mayor of the City of London in 1502, forming the Worshipful Company of Painter-Stainers. The guild standardised the craft and acted as a protector of the trade secrets. In 1599, the guild asked Parliament for protection, which was eventually granted in a bill of 1606, which granted the trade protection from outside competition such as plasterers.[2]
Dave, you said it best! Every pro painting contractor truly worth their salt would and should cut and paste exactly what you say here about where customary and legitimate practices and expectations should be in regards to what customers should expect from contractors and how contractors should professionally deal with their customers. By the way, Dave, if you work in the Atlanta area, I would like to hire you! Thank you for your valuable advice!
Painting contractors must also carry out administrative and marketing duties. They prepare final accounts for customers based on the original estimates and any additional work. They analyze the cost of the job compared with the estimate to calculate their profit. They market their business through activities such as setting up websites, asking customers for references or contacting property maintenance companies with details of their services.
My house is a mess. Virtually everything needs serious work. Dixon gives me the confidence to tackle one project after another. His writing style is straightforward, reassuring, inspirational. He tells you everything you need to know to complete a job and be happy with it. Every painstaking stage of prep, helpful tips on additives, priming, carrying out each stage of painting process under every possible circumstance. I borrowed Dixon's book from the library so often that I spent more than the cost of it on overdue fines.
Being in the business for 25+ years I have had the privilege of working with thousands of clients. Although they all came from different circumstances and backgrounds they all had one common goal in mind. Every one of them wanted to be respected, receive top value for their money, and get the best possible paint job for their most prized possession, their house!
Third: The contractor buys the materials. We get them at a better rate and customers really don't know what they are getting into by being a material racer. Once again, I'm not referring to the guys that paint a bedroom or 2 a week. Tell the homeowner to go grab 50 gallons of paint, $300.00 worth of sundries and related job cost items and I'd be interested to see how it works for them....IT WILL NOT. And if were talking about people getting taken advantage of here, the paint suppliers with no relationship to a homeowner will 100% GOUGE the customer and completely take advantage of them with pricing. Contractors will pay nearly half the price and will still save the customers money marking up paint 10-15%.
Keep in mind that color can impact the way a room appears in many ways. Light colors may help brighten a darker space. Cool colors will recede visually from the eye, and make a small space appear bigger. Warm colors contract visually, which can make larger spaces appear smaller or more cozy. Combining cool and warm tones in one room - like with accent walls - can visually change the shape of a room, making rectangles look more like squares.

the price can always be adjusted based on on or off season, amount of colors to be used. A job like this can be done in 2 days and much quicker with a helper. I charge a bit more than others just because its quality work done professionally. Theres others that charge more than this just because they can on the on season and most people dont get a 2nd bid...
Painting contractors must also carry out administrative and marketing duties. They prepare final accounts for customers based on the original estimates and any additional work. They analyze the cost of the job compared with the estimate to calculate their profit. They market their business through activities such as setting up websites, asking customers for references or contacting property maintenance companies with details of their services.
"We used Next Door Painting for the exterior and one room on the interior of our house. Scott Finkelstein and his crew did an excellent job. They were reasonably priced, very professional, helpful with ideas and accommodating to our wishes and needs. I was contacted within an hour after my Thumbtack request, made an appointment for an estimate and was impressed with the knowledge and quality of the presentation. I definitely recommend them for the job and will use them again. Christy Todd Flower Mound, TX"

I was a painting contractor for many years and never asked for a deposit upfront. A good contractor should have great credit with his suppliers and an even better contract if the deal should go south before the job is done. Get to know your customer and explain how each paint covers so they understand fully before you have to apply 3 or 4 coats. If you didn't bid your job right and the client has already signed the contract then that is on you not the client. Yes I haven had to eat the difference but the client was happy and a return customer for years so I made up for it.


Historically, the painter was responsible for the mixing of the paint; keeping a ready supply of pigments, oils, thinners and driers. The painter would use his experience to determine a suitable mixture depending on the nature of the job. In modern times, the painter is primarily responsible for preparation of the surface to be painted, such as patching holes in drywall, using masking tape and other protection on surfaces not to be painted, applying the paint and then cleaning up.[2]

The only time it's acceptable to mix water in the paint is when you're using a deep or ultra deep base paint to reduce its stickiness, which is rare with new paint technology. Dark primary colors are composed almost entirely of tint that makes it very hard to work with without adding water. (You never use a sprayer and need to thin paint.?) If i was still in the industry I'd take the time to make a better article than this. Take this for a grain of slat. Use a reputable painter or someone you know you can trust or has been referred to you by someone you trust. I wouldn't hire anyone I had to watch like a hawk to make sure they're not screwing me.

×