When selecting a color scheme for the home’s exterior homeowners can choose color options that will correct flaws that they may feel exist with their home and property.  Some examples include utilizing two shades of a single color to make a home appear appropriately sized when the home may be too large or too tall.  To accomplish this effect individuals will want to place the darker tone on the upper level of the home’s exterior.  Smaller windows can appear more proportionately sized by trimming them in a lighter tone of paint.  Darker colors make a space or feature appear smaller.  The same effect can be obtained for homes positioned further away from a curb.  By using lighter tones the home will not feel camouflaged.
Concrete walls must always be prepared before painting, but in some cases previous finishes will also have to be removed so that paint doesn't peel or chip off. Additionally, special sealants, primers and paints may be applied to ensure concrete's endurance in face of the specific elements. Depending on the wall's condition and exposure to the sun, painting professionals will usually estimate between $500 (~250 sq. ft.) and $2,000 (~1,000 sq. ft.), depending on wall area to cover.
Most painters have no problem painting doors in place, but they recommend you lay the door on sawhorses and work horizontally. If you have a paneled door, start with the panels and work from the outside edges in toward the center. "Watch the corners — paint loves to puddle," warns Dixon. While the paint is still wet, lightly "tip off" the panel with an almost dry brush. (Tipping off is pulling the brush over the surface to level out the finish.) When painting the stiles (vertical) and rails (horizontal) just follow the grain of the wood. When the grain changes abruptly, for instance, where the rail meets the stile, don't stop your brush stroke — you'll only leave a lump of paint. Apply paint across the joint with a full stroke, and then tip off the overlapping section by pulling the brush in the direction of the grain. "Make sure the door is dry before painting the opposite side or rehanging it," says Maceyunas.
Enforcement of this Act by the Painter-Stainers Company was sought up until the early 19th century, with master painters gathering irregularly to decide the fees that a journeyman could charge, and also instigating an early version of a job centre in 1769, advertising in the London newspapers a "house of call" system to advertise for journeymen and also for journeymen to advertise for work. The guild's power in setting the fee a journeyman could charge was eventually overturned by law in 1827, and the period after this saw the guild's power diminish, along with that of the other guilds; the guilds were superseded by trade unions, with the Operative United Painters' Union forming sometime around 1831.[2]
As an owners rep and former estimator for a gc i do expect to pay a reasonable deposit say 10 percent and then weekly progress payments. I am asking the painter to book his time and to do the work on my schedule. Most painting companies are not huge operations they will pay their staff weekly. For most repaints i ask for one tinted primer coat and one finish coat for 100 percent coverage. New work gets one tinted primer and two finish coats for 100 percent coverage. The cost of the paint is not really that different for colors or finish. Brands like european fine paint and C2 are more expensive than Ben Moore and sometimes more difficult to roll based on their consistency. Some home depot brands are as expensive as the Ben Moore and of equal quality others aren't. Red paints are notorious for number of coats required and special priming requirements.
With that said, here's the reality of that particular scenario. Painters do put water in the paint, but not for reasons you would think. Some materials need to have their viscosity manipulated in order to slow drying time, allowing gravity to 'smooth' out the product for a better finish. It also prevents 'drags' and 'sausages'. I personally try not to do it too often, but from time to time I have to. I want my client to have a proper finish.
When painting the trim, you don’t have to be neat. Just concentrate on getting a smooth finish on the wood. Don’t worry if the trim paint gets onto the walls. You’ll cover it later when painting the walls. Once the trim is completely painted and dry (at least 24 hours), tape it off (using an “easy release” painter’s tape), then paint the ceiling, then the walls.

This was very helpful. I wonder if i would really follow through and check to see if my painter was cheating me. I used a painter I found on Angie's List. This was 5 years ago. He did a great job. I know he did patching only for about a day and a half. We decided on the kind of paint before he started. that is what he used. I don't know if I could stay on top of him and watch him open every can of paint.


The article and comments were great information to have before deciding how to go about getting a painting job done. I think the important point is that there are several key choices (who to do the work; color, sheen, quality, of paint; how many coats; amount of prep/repairs to be done and by whom, how long the job will take, provisions for changes, how detailed the contract needs to be; advanced deposit/progress payments/final payment; final inspection, etc.) that need to be made and it requires advanced research and planning in order to become well enough informed to make the right choices. Then it requires spending sufficient time to check materials and inspect the quality of the work while it is on-going, raher than waiting to do it all at the end. President Reagan's philosophy of "Trust, but verify." applies.
Thanks, all, for your time & efforts adding to the article & comments, especially Dave urging requesting both General Liability AND Worker Compensation insurance certificates to protect from real & fraudulent liability--from my experience especially in California, where insurance fraud is a popular income thief, even causing car collisions to collect.

Painting Company CO

×